BF135A•BF150A 3. Perform the troubleshooting by referring to the “Trou- bleshooting Guide by DTC” (P. 5-15) or “Troubleshoot- ing Guide by No. of Blinks” (P. 5-59). Check each connector and wire harness for secure connection and damage before troubleshooting. Repair the connector and wire harness if necessary. 5.TROUBLESHOOTING The ECM (Engine Control Module) has the self-diagnosis function which memorizes the failure code and turns the MIL (Malfunction Indicator Light) ON when it detects an abnormality with the input/output system.
If the MIL does not come ON but the engine failure (abnormality other than monitoring ECM) occurred, detect the probable problem part by referring to the Quick Reference Chart of Troubleshooting by System on page 5-12, and troubleshoot accordingly. 4. After troubleshooting, perform repairs as needed and perform the necessary work (P. 5-14 or 5-58). • HOW TO CARRY OUT TROUBLESHOOTING When the MIL comes ON or blinks or any abnormality occurs during running, identify the problem detected by ECM according to the following procedure, and trou- bleshoot accordingly. To troubleshoot, connect the tester probe to a commer- cially available digital circuit tester.
Note that the tester probe must agree with the connector terminal of the digi- tal circuit tester not to apply excessive force to the con- nector terminal. 1. Turn the ignition switch ON and check that the MIL comes ON. PGM-FI MIL 2. When the MIL is ON or blinking, check the DTC (Diagnostic Trouble Code) using the HDS tester (P. 5- 13). Or, use the short connector to blink the MIL and trou- bleshoot the problem indicated by the number of blinks of the MIL (P. 5-57). 5-11