BF135A•BF150A • WHEN USING HDS POCKET TESTER DURING CRUISING 1. Remove the engine cover and the electric part cover (Section 4). 2. Remove the cap from the under cover front bracket. Route the extension wire in the HDS pocket tester kit through the front cover bracket. Set the grommet on the under cover front bracket securely. 6. TROUBLESHOOTING WITH HDS TESTER • DTC (DIAGNOSTIC TROUBLE CODE) CHECK 1. Remove the engine cover and the electric part cover (Section 4). 2. Disconnect the 4P (Red) connector and connect the HDS pocket tester to the data link connector (DLC). 4P CONNECTOR (RED) UNDER COVER FRONT BRACKET CAP 3.
Disconnect the red 4P connector from the DLC (Data Link Connector) and secure the DLC wire as sown. Route the extension wire of the tester in the position shown so that it does not interfere with the parts. 4. Connect the extension wire to the DLC. TESTER WIRE DATA LINK CONNECTOR (DLC) CLAMP DLC HDS POCKET TESTER 3. Turn the ignition switch ON and check the DTC shown on the HDS pocket tester. Refer to the HDS pocket tester's operation manual for how to use the HDS pocket tester. EXTENSION WIRE OF TESTER 5-13