BF135A•BF150A 5-15 a. TROUBLESHOOTING GUIDE BY DTC DTC PGM-FI MIL Detected unit Probable problem part Ref.
page – or 0-2, 0-5, 0-8 MIL does not come ON/blinks ECM • Open circuit in MIL wire • Blown MIL bulb • Open circuit in ECM ground wire or poor grounding • Faulty ECM 5-18 – or 0-2, 0-5, 0-8 MIL stays ON ECM • Open circuit in ECM power supply line • Short circuit in data link connector wire • Short circuit in MIL wire • Short circuit in sensor power supply line • Faulty ECM 5-21 3-1 MIL stays ON MAP sensor (Voltage too low) • Short circuit in MAP sensor wire • Faulty MAP sensor • Faulty ECM 5-28 3-2 MIL stays ON MAP sensor (Voltage too high) • Open circuit in MAP sensor wire • Faulty MAP sensor • Faulty ECM 5-29 4-1 MIL stays ON CKP sensor (No pulse) • Open/short circuit in CKP sensor wire • CKP sensor • Faulty ECM 5-30 4-2 MIL stays ON CKP sensor (Abnormal pulse) • Faulty CKP sensor • Faulty ECM 5-32 6-1 MIL stays ON ECT sensor 1 (Voltage too low) • Short circuit in ECT sensor 1 • Faulty ECT sensor 1 • Faulty ECM 5-33 6-2 MIL stays ON ECT sensor 1 (Voltage too high) • Open circuit in ECT sensor 1 wire • Faulty ECT sensor 1 • Faulty ECM 5-33 7-1 MIL stays ON TP sensor (Voltage too low) • Open/short circuit in TP sensor wire • Faulty TP sensor • Faulty ECM 5-34 7-2 MIL stays ON TP sensor (Voltage too high) • Open circuit in TP sensor wire • Faulty TP sensor • Faulty ECM 5-35 8-1 MIL stays ON CMP sensor (No pulse) • Open/short circuit in CMP sensor • Faulty DC1 sensor • Faulty ECM 5-36 8-2 MIL stays ON CMP sensor (Abnormal pulse) • Open/short circuit in CMP sensor • Faulty CMP sensor • Faulty ECM 5-37 –:
DTC does not appear.