BF135A•BF150A b. TROUBLESHOOTING 2. Main power line check -1. Disconnect the remote control harness 14P connector. -2. Measure the voltage between the No. 3 (White/Black) terminal of the main harness side 14P connector and the engine ground. • Note that voltage is constantly applied to the White/Black terminal.Take care not to short-circuit the terminal. MIL Does Not Come ON 1. Fuse check -1. Turn the ignition switch ON and check that the warning buzzer sounds twice. Does the buzzer sound twice? YES – Perform “6. Alternator indicator light check” NO – Go to the step 2. MAIN HARNESS SIDE 14P CONNECTOR BLACK/WHITE -2. Check the No. 4 (15A) fuse. Is the fuse normal? YES – Go to the step 3.
NO – Repair open in the wire between the No. 4 fuse and the ECM, and between the No. 4 fuse and the injector. After repair, replace the No. 4 fuse. VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Go to the step 3. NO – Repair open in the main harness. -3. Check the No. 7 (30A) fuse. Is the fuse normal? YES – Go to the step 4. NO – Repair short in the wire between the PGM-FI main relay and the fuse box, and between the PGM-FI main relay and the starter magnetic switch. After repair, replace the No. 7 fuse. -3. Turn the ignition switch ON. Check for continuity between the No. 1 (White/Black) terminal and the No.
2 (Black/Yellow) terminal of the remote control box har- ness side 14P connector. -4. Check the No. 3 (30A) fuse. REMOTE CONTROL HARNESS SIDE 14P CONNECTOR Is the fuse normal? YES – Perform “2. Main power line check”. NO – Repair short in the wire between the fuse box and the ignition switch, between the fuse box and the alternator, and between the fuse box and the power trim/tilt switch or power tilt switch. After repair, replace the No. 3 fuse. BLACK/YELLOW WHITE/BLACK VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “3. IGP power line check”. NO – Go to the step 4. -4. Check the ignition switch (P. 16-9). Is the ignition switch normal?
YES – Repair open in the remote control box har- ness. NO – The ignition switch is faulty. 5-18