BF135A•BF150A Tachometer Malfunction -4. Check for the continuity between the No. 12 (Gray) ter- minal of the main harness side 14P connector and the No. 33 (Gray) terminal of the ECM harness side con- nector B. 1. Engine speed check using the HDS pocket tester. -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Start the engine and check the engine speed with the HDS pocket tester. MAIN HARNESS SIDE 14P CONNECTOR ECM CONNECTOR B Do the tachometer and tester readings agree? YES – Normal (Temporary problem has been removed.) NO – Perform “2.Tachometer power line check”. *Tolerance of genuine Honda tachometer:
At 2,000 rpm:±160 rpm At 4,000 rpm:+200 rpm –150 rpm At 6,000 rpm:+200 rpm –150 rpm TACHO (GRAY) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Check for open in the remote control harness and meter harness wires.If the harnesses are normal, substitute a known-good ECM and recheck. NO – Repair open in the wire of the main harness. 2. Tachometer power line check -1. Turn the ignition switch OFF and disconnect the Yellow/Black and the Black terminals of the tachome- ter. -2. Turn the ignition switch ON and measure the voltage between the meter harness side Yellow/Black and the Black terminals. Is there the battery voltage? YES – Perform “3.Tachometer pulse line check”.
NO – Repair open in the wire of the meter harness. 3. Tachometer pulse line check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2. Disconnect the remote control harness 14P connector. -3. Check for the continuity between the No. 12 (Gray) ter- minal of the main harness side 14P connector and the engine ground. MAIN HARNESS SIDE 14P CONNECTOR GRAY VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the main harness. NO – Go to the step 4. 5-27