honda — Programmed Fuel Injection

BF135A•BF150A ECM Troubleshooting MAP Sensor Troubleshooting DTC 0-2, 0-5, 0-8: Inside of ECM is faulty 1. Symptom reproduction test -1. Connect the HDS pocket tester. -2. Turn the ignition switch ON and wait for 1 second or more. -3. Clear the DTC once. -4. Start the engine and check the DTC again. DTC 3-1: MAP sensor voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Check the MAP sensor voltage using the HDS pocket tester. Does the DTC 0-2, 0-5, and/or 0-8 appear? YES – Substitute a known-good ECM and recheck.

NO – Temporary failure inside ECM (Disappeared) Is the measured voltage 0.22 to 3.15V? YES – Temporary failure (Disappeared) NO – Perform “2. MAP sensor signal line short-cir- cuit test”. 2. MAP sensor signal line short-circuit test -1. Turn the ignition switch OFF and disconnect the MAP sensor 3P connector. -2. Disconnect the ECM connector A. -3. Check for the continuity between the No.2 (White/Red) terminal of the MAP sensor harness side 3P connec- tor and the body ground. MAP SENSOR HARNESS SIDE 3P CONNECTOR PB (WHITE/RED) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the MAP sensor and ECM. NO – Perform “3. MAP sensor check”. 3.

MAP sensor check -1. Connect the ECM connector A and the MAP sensor 3P connector. -2. Turn the ignition switch ON and read the MAP sensor voltage using the HDS pocket tester. Is the voltage 2.76 – 2.96V? YES – Substitute a known-good ECM and recheck. NO – Replace the MAP sensor. 5-28