BF135A•BF150A DTC 3-2: MAP sensor voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Check PB voltage using the HDS pocket tester. Is there the continuity? YES – Perform “4. MAP sensor ground line open cir- cuit check”. NO – Repair open in the wire between the MAP sensor and the ECM. 4. MAP sensor ground line open circuit check -1. Check for the continuity between the No. 1 (Green/Red) terminal of the MAP sensor harness side 3P connector and the body ground. Is the measured voltage 0.22 – 3.15V?
YES – Temporary failure (Disappeared) NO – Perform “2. MAP sensor power line check”. MAP SENSOR HARNESS SIDE 3P CONNECTOR 2. MAP sensor power line check -1. Turn the ignition switch OFF and disconnect the MAP sensor 3P connector. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 3 (Brown/Yellow) terminal and the No. 1 (Green/Red) terminal of the MAP sensor harness side 3P connector. SG1 (GREEN/RED) VIEWED FROM THE TERMINAL SIDE MAP SENSOR HARNESS SIDE 3P CONNECTOR SG1 (GREEN/RED) VCC1 (BROWN/YELLOW) Is there the continuity? YES – Perform “5. MAP sensor signal line open cir- cuit check”. NO – Repair open in the wire between the MAP sensor and the ECM.
VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform “5. MAP sensor signal line open cir- cuit check”. NO – Perform “3. MAP sensor power line open cir- cuit check”. 5. MAP sensor signal line open circuit check -1. Connect the ECM connector A. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (White/Red) terminal and the No. 1 (Green/Red) terminal of the MAP sensor harness side 3P connector. 3. MAP sensor power line open circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2. Check for the continuity between the No. 3 (Brown/Yellow) terminal of the MAP sensor harness side 3P connector and the No.
4 (Brown/Yellow) termi- nal of the ECM harness side connector B. MAP SENSOR HARNESS SIDE 3P CONNECTOR PB (WHITE/RED) SG1 (GREEN/RED) ECM CONNECTOR B MAP SENSOR HARNESS SIDE 3P CONNECTOR VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform “7. MAP sensor check”. NO – Perform “6. MAP sensor signal line open cir- cuit check”. VCC1 (BROWN/YELLOW) VIEWED FROM THE TERMINAL SIDE 5-29