BF135A•BF150A 6. MAP sensor signal line open circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2. Check for the continuity between the No.2 (White/Red) terminal of the MAP sensor harness side 3P connec- tor and the No. 5 (White/Red) terminal of the ECM con- nector B. CKP Sensor Troubleshooting DTC 4-1: No CKP pulse 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and let it run at idling under no load. -3. Check the DTC using the HDS pocket tester. ECM CONNECTOR B MAP SENSOR HARNESS SIDE 3P CONNECTOR Does the DTC 4-1 appear?
YES – Perform “2. CKP sensor power line check”. NO – Temporary failure (Disappeared) 2. CKP sensor power line check -1. Turn the ignition switch OFF and disconnect the CKP sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 1 (Yellow/Black) terminal and the No. 2 (Green/Red) terminal of the CKP sensor harness side connector. PB (WHITE/RED) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “7. MAP sensor check”. NO – Repair open in the wire between the MAP sensor and ECM. CKP SENSOR HARNESS SIDE 3P CONNECTOR LG1 (GREEN/RED) IGP (YELLOW/BLACK) 7. MAP sensor check -1. Connect the ECM connector B and the MAP sensor 3P connector. -2.
Turn the ignition switch ON and read the PB voltage using the HDS pocket tester. VIEWED FROM THE TERMINAL SIDE Is the voltage 2.76 – 2.96V? YES – Substitute a known-good ECM and recheck. NO – Replace the MAP sensor. Is there the battery voltage? YES – Perform “4. CKP sensor signal line open cir- cuit check”. NO – Perform “3. CKP sensor power line open cir- cuit check”. 5-30