BF135A•BF150A ECT Sensor 1 Troubleshooting DTC 6-2: ECT sensor 1 voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 1 voltage using the HDS pocket tester. DTC 6-1: ECT sensor 1 voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Check the ECT sensor 1 voltage using the HDS pock- et tester. Is the measurement 0.23 – 3.15V?
YES – Temporary failure (Disappeared) NO – Go to the step 2. Is the measurement 0.23 – 3.15V? YES – Temporary failure (Disappeared) NO – Perform “2. ECT sensor 1 line short circuit check”. 2. ECT sensor 1 line check -1. Turn the ignition switch OFF and disconnect the ECT sensor 1 connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 2 (Red/White) and the No. 1 (Green/Red) terminals of the ECT sensor 1 harness side 2P connector. 2. ECT sensor 1 line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2.
Check for the continuity between the No.2 (Red/White) terminal of the ECT sensor 1 harness side 2P con- nector and the body ground. ECT SENSOR 1 HARNESS SIDE 2P CONNECTOR ECT SENSOR 1 HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) TE (RED/WHITE) TE (RED/WHITE) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is the measurement 4.30 – 5.25V? YES – Perform “4. ECT sensor 1 check”. NO – Perform “3. ECT sensor 1 signal line open cir- cuit check”. Is there the continuity? YES – Repair short in the wire between the ECM and the ECT sensor 1. NO – Perform “3. ECT sensor 1 check”. 3. ECT sensor 1 line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No.
2 (Red/White) terminal of the ECT sensor 1 harness side 2P connector and the engine ground. 3. ECT sensor 1 check -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON. Check the engine coolant temperature with the HDS pocket tester. ECT SENSOR 1 HARNESS SIDE 2P CONNECTOR Is the engine coolant temperature normal? YES – Substitute a known–good ECM and recheck. NO – Replace the ECT sensor 1 and recheck. TE (RED/WHIT) VIEWED FROM THE TERMINAL SIDE 5-33