BF135A•BF150A TP Sensor Troubleshooting Is the measurement 4.30 – 5.25V? YES – Repair open in the sensor ground line. NO – Repair open in the wire between the ECM and the ECT sensor 1. DTC 7-1: TP sensor voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the TP sensor voltage using the HDS pocket tester. 4. ECT sensor 1 check -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON and check the engine coolant temperature with the HDS pocket tester. Is the engine coolant temperature normal?
YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 1 and recheck. Is the measurement 0.08 – 4.92V? YES – Temporary failure (Disappeared) NO – Perform “2. TP sensor signal line short circuit check”. 2. TP sensor signal line short circuit check -1. Turn the ignition switch OFF and disconnect the TP sensor connector. -2. Disconnect the ECM connector B. -3. Check for continuity between the No. 2 (Red/Black) ter- minal of the TP sensor harness side 3P connector and the engine ground. TP SENSOR HARNESS SIDE 3P CONNECTOR THL (RED/BLACK) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the TP sen- sor and the ECM.
NO – Perform “3.TP sensor check”. 3. TP sensor check -1. Connect the ECM connector B and the TP sensor 3P connector. -2. Turn the ignition switch ON and measure the TP sen- sor voltage using the HDS pocket tester. Is the measurement voltage 4.49 – 4.85V at full open throttle and 0.44 – 0.56V at full close throttle? YES – Substitute a known-good ECM and recheck. NO – Replace the TP sensor. 5-34