BF135A•BF150A DTC 7-2: TP sensor voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the TP sensor voltage with the HDS pocket tester. 3. TP sensor power line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 3 (Brown/White) terminal of the TP sensor harness side 3P connector and the engine ground. TP SENSOR HARNESS SIDE 3P CONNECTOR Is the measurement 0.08 – 4.92V? YES – Temporary failure (Disappeared) NO – Perform “2.TP sensor power line check”. VCC2 (BROWN/WHITE) 2. TP sensor power line check -1.
Turn the ignition switch OFF and disconnect the TP sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (Brown/White) and the No. 1 (Green/Red) terminals of the TP sensor harness side 3P connector. VIEWED FROM THE TERMINAL SIDE Is the measurement 4.75 – 5.25V? YES – Repair open in the wire between the TP sen- sor and the engine ground. NO – Repair open in the wire between the TP sen- sor and the ECM. TP SENSOR HARNESS SIDE 3P CONNECTOR VCC2 (BROWN/WHITE) SG2 (GREEN/RED) 4. TP sensor signal line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No.
2 (Red/Black) terminal of the TP sen- sor harness side 3P connector and the engine ground. VIEWED FROM THE TERMINAL SIDE TP SENSOR HARNESS SIDE 3P CONNECTOR Is the measurement 4.75 – 5.25V? YES – Perform “4. TP sensor signal line open circuit check”. NO – Perform “3.TP sensor power line open circuit check”. TH (RED/BLACK) VIEWED FROM THE TERMINAL SIDE Is the measurement 4.75 – 5.25V? YES – Perform “5.TP sensor check”. NO – Repair open in the TP sensor and the ECM. 5-35