BF135A•BF150A 5. TP sensor check -1. Turn the ignition switch OFF and connect the TP sen- sor 3P connector. -2. Measure the TP sensor voltage using the HDS pocket tester. • CMP Sensor Troubleshooting DTC 8-1: No CMP sensor pulse 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and let it run at idling under no load. -3. Check the DTC using the HDS pocket tester. Is the measurement voltage 4.49 – 4.85V at full open throttle and 0.44 – 0.56V at full close throttle? YES – Substitute a known-good ECM and recheck. NO – Replace the TP sensor. Does the DTC 8-1 appear?
YES – Check the pulse plate. If it is normal, perform CMP sensor power line check”. If it is abnormal, replace the pulse plate and recheck. NO – Temporary failure (Disappeared) 2. CMP sensor power line check -1. Turn the ignition switch OFF and disconnect the CMP sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 1 (Yellow/Black) terminal and the No. 2 (Green/Red) terminal of the CMP sensor harness side 3P connector. CMP SENSOR HARNESS SIDE 3P CONNECTOR IGP (YELLOW/BLACK) LG1 (GREEN/RED) VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Perform “4. CMP sensor signal line open cir- cuit check”. NO – Perform “3.
CMP sensor power line open cir- cuit check”. 5-36