BF135A•BF150A 3. CMP sensor power line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 1 (Yellow/Black) terminal of the CMP sensor harness side 3P connector and the engine ground. DTC 8-2: CMP sensor pulse is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and let it run at idling under no load. -3. Check the DTC using the HDS pocket tester. CMP SENSOR HARNESS SIDE 3P CONNECTOR IGP (YELLOW/BLACK) Does the DTC 8-2 appear? YES – Replace the CMP sensor and recheck.
If the DTC 8-2 appears again, substitute a known- good ECM and recheck. NO – Temporary failure (Disappeared) VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Repair open in the CMP sensor ground line. NO – Repair open in the wire between the No. 4 fuse and the CMP sensor. 4. CMP sensor signal line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 3 (Green) terminal of the CMP sensor harness side 3P connector and the engine ground. CMP SENSOR HARNESS SIDE 3P CONNECTOR TDC (GREEN) VIEWED FROM THE TERMINAL SIDE Is the measurement voltage 4.75 – 5.25V? YES – Perform “5. CMP sensor check”.
NO – Repair open in the wire between the CMP sensor and the ECM. 5. CMP sensor check -1. Connect the HDS pocket tester and clear the DTC once. -2. Start the engine and let it run at idling under no load. Check the DTC using the HDS pocket tester. Does the DTC 8-1 appear? YES – Replace the CMP sensor and recheck. If the DTC 8-1 appears again, substitute a known- good ECM and recheck. NO – End of the check 5-37