BF135A•BF150A IAT Sensor Troubleshooting DTC 10-2: IAT sensor voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the IAT sensor (TA) voltage using the HDS pocket tester. DTC 10-1: IAT sensor voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the IAT sensor (TA) voltage using the HDS pocket tester. Is the measured voltage 0.08 – 4.92V?
YES – Temporary failure (Disappeared) NO – Perform “2. IAT sensor signal line open circuit check”. Is the measurement voltage 0.08 – 4.92V? YES – Temporary failure (Disappeared) NO – Perform “2. IAT sensor line short circuit check”. 2. IAT sensor signal line open circuit check -1. Turn the ignition switch OFF and disconnect the IAT sensor 2P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 2 (Red/Yellow) terminal of the IAT sensor harness side 2P connector and the engine ground. 2. IAT sensor line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2. Check for the continuity between the No.
2 (Red/Yellow) terminal of the IAT sensor harness side 2P connector and the body ground. IAT SENSOR HARNESS SIDE 2P CONNECTOR IAT SENSOR HARNESS SIDE 2P CONNECTOR TA (RED/YELLOW) TA (RED/YELLOW) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform “3. IAT sensor ground line open cir- cuit check”. NO – Repair open in the wire between the IAT sen- sor and the ECM. Is there the continuity? YES – Repair short in the wire between the ECM and the IAT sensor. NO – Perform “3. IAT sensor check”. 3. IAT sensor ground line open circuit check -1. Turn the ignition switch OFF. -2. Check for the continuity between the No.
1 (Green/Red) terminal of the IAT sensor harness side 2P connector and the body ground. 3. IAT sensor check -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON and check the intake air temperature using the HDS pocket tester. Does the measurement correspond to the ambient temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the IAT sensor with a new one and recheck. IAT SENSOR HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) VIEWED FROM THE TERMINAL SIDE 5-38