BF135A•BF150A BARO Sensor Troubleshooting Is there the continuity? YES – Perform “4. IAT sensor check”. NO – Repair open in the wire between the IAT sen- sor and the engine ground. DTC 13-1: BARO sensor voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the BARO sensor (PA) voltage using the HDS pocket tester. 4. IAT sensor check -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON and check the intake air temperature using the HDS pocket tester.
Does the measurement correspond to the ambient temperature? YES – Substitute a known–good ECM and recheck. NO – Substitute a known–good IAT sensor and recheck. Is the measurement voltage 1.58 – 4.49V? YES – Temporary failure (Disappeared) NO – Perform “2. BARO sensor signal line short cir- cuit check”. 2. BARO sensor signal line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2. Check for the continuity between the No. 2 (White/Blue) terminal of the BARO sensor harness side 3P connector and the body ground. BARO SENSOR HARNESS SIDE 3P CONNECTOR PA (WHITE/BLUE) VIEWED FROM THE TERMINAL SIDE Is there the continuity?
YES – Repair short in the wire between the ECM and the BARO sensor. NO – Perform “3. BARO sensor check”. 3. BARO sensor check -1. Turn the ignition switch OFF and connect the BARO sensor connector and the ECM connector B. -2. Turn the ignition switch ON. Measure the BARO sen- sor voltage using the HDS pocket tester. Is the measurement voltage 2.76 – 2.96V? YES – Substitute a known-good ECM and recheck. NO – Replace the BARO sensor and recheck. 5-39