honda — Programmed Fuel Injection

BF135A•BF150A DTC 13-2: BARO sensor voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the BARO sensor (PA) voltage using the HDS pocket tester. Is the measured voltage 4.75 – 5.25V? YES – Repair open in the wire between the BARO sensor and the engine ground. NO – Repair open in the wire between the BARO sensor and the ECM. 4. BARO sensor signal line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 2 (White/Blue) terminal of the BARO sensor harness side 3P connector and the engine ground.

Is the measurement voltage 1.58 – 4.49V? YES – Temporary failure (Disappeared) NO – Perform “2. BARO sensor power line check”. 2. BARO sensor power line check -1. Turn the ignition switch OFF and disconnect the BARO sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (Brown/White) and the No. 1 (Green/Red) terminals of the BARO sensor harness side 3P connector. BARO SENSOR HARNESS SIDE 3P CONNECTOR PA (WHITE/BLUE) VIEWED FROM THE TERMINAL SIDE BARO SENSOR HARNESS SIDE 3P CONNECTOR SG2 (GREEN/RED) VCC2 (BROWN/WHITE) Is the measured voltage 4.75 – 5.25V? YES – Perform “5. BARO sensor check”.

NO – Repair open in the wire between the BARO sensor and the ECM. VIEWED FROM THE TERMINAL SIDE 5. BARO sensor check -1. Turn the ignition switch OFF and connect the BARO sensor connector. -2. Turn the ignition switch ON and measure the BARO sensor voltage using the HDS pocket tester. Is the measurement voltage 4.75 – 5.25V? YES – Perform “4. BARO sensor signal line open cir- cuit check”. NO – Perform “3.BARO sensor power line open cir- cuit check”. Is the measured voltage 2.76 – 2.96V? YES – Substitute a known-good ECM and recheck. NO – Replace the BARO sensor and recheck. 3. BARO sensor power line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No.

3 (Brown/White) terminal of the BARO sensor harness side 3P connector and the engine ground. BARO SENSOR HARNESS SIDE 3P CONNECTOR VCC2 (BROWN/WHITE) VIEWED FROM THE TERMINAL SIDE 5-40