honda — Programmed Fuel Injection

BF135A•BF150A IAC Valve Troubleshooting -2. Check for the continuity between the IAC valve No. 2 terminal and the body ground. DTC 14-1: IAC valve current is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and let it run at idling under no load. -3. Measure the engine speed using the HDS pocket tester. IAC VALVE SIDE 2P CONNECTOR Is the engine speed 650 min -1 (rpm) or above? YES – Temporary failure (Disappeared) NO – Perform “2. IAC valve open circuit check”. VIEWED FROM THE TERMINAL SIDE 2. IAC valve open circuit check -1.

Turn the ignition switch OFF and disconnect the IAC valve 2P connector. -2. Measure the resistance between the No. 1 and No. 2 terminals of the IAC valve. Is there the continuity? YES – Replace the IAC valve. NO – Perform “4. IAC valve line open circuit check”. 4. IAC valve line open circuit check -1. Connect the IAC valve 2P connector. -2. Disconnect the ECM connector B. -3. Measure the resistance between the No. 26 (Green/White) and the No. 34 (Black) terminals of the ECM connector B. IAC VALVE SIDE 2P CONNECTOR ECM CONNECTOR B VIEWED FROM THE TERMINAL SIDE EACVM (BLACK) EACVP (GREEN/WHITE) Is the measured resistance 8 – 12 ? YES – Perform “3. IAC valve short circuit check”.

NO – Replace the IAC valve. 3. IAC valve short circuit check -1. Check for the continuity between the IAC valve No. 1 terminal and the body ground. VIEWED FROM THE TERMINAL SIDE IAC VALVE SIDE 2P CONNECTOR ? YES – Perform “5. IAC valve line short circuit check”. NO – Repair open in the wire between the ECM and the IAC valve. Is the measured resistance 10 – 13 VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Replace the IAC valve. NO – Go to the step 2. 5-41