honda — Programmed Fuel Injection

BF135A•BF150A 5. IAC valve line short circuit check -1. Check for the continuity between the No. 26 (Green/White) terminal of the ECM connector B and the engine ground, and between the No. 34 (Black) ter- minal of the ECM connector B and the engine ground. • VTEC Solenoid Valve Troubleshooting DTC 21-1:VTEC solenoid valve output is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up for 5 minutes by run- ning the engine at 3,000 min -1 (rpm) under no load. -3. Disconnect the neutral switch 2P connector. -4.

Increase the engine speed gradually and run the engine at 4,500 min -1 (rpm) for a few seconds. -5. Check the DTC again using the HDS pocket tester. ECM CONNECTOR B EACVM (BLACK) EACVP (GREEN/WHITE) Does the DTC 21-1 appear? YES – Perform “2. Spool solenoid valve check”. NO – Temporary failure (Disappeared) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECM and the IAC valve. NO – Substitute a known-good ECM and recheck. 2. Spool solenoid valve check -1. Turn the ignition switch OFF and disconnect the spool solenoid valve connector. -2.

Measure the resistance between the spool solenoid valve side 1P connector (Green/White) terminal and the body ground. SOLENOID VALVE SIDE 1P CONNECTOR VIEWED FROM THE TERMINAL SIDE ? YES – Perform “3. VTEC signal line short circuit check”. NO – Replace the spool solenoid valve. Is the measured resistance 12 – 18 5-42