BF135A•BF150A 3. VTEC signal line short circuit check -1. Disconnect the ECM connector A. -2. Check for the continuity between the No. 20 (Green/Yellow) terminal of the ECM connector A and the body ground. • Knock Sensor Troubleshooting DTC 23-1: Knock sensor detects failure 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up for 5 minutes or more by running the engine at 5,000 min -1 (rpm) or more under no load. -3. Check the DTC again with the HDS pocket tester. ECM CONNECTOR A VTS (GREEN/YELLOW) Does the DTC 23-1 appear? YES – Perform “2.
Knock sensor signal line open cir- cuit check”. NO – Temporary failure (Disappeared) VIEWED FROM THE TERMINAL SIDE 2. Knock sensor signal line open circuit check -1. Turn the ignition switch OFF. Disconnect the knock sensor connector and the ECM connector A. -2. Check for the continuity between the (Red/Blue) termi- nal of the knock sensor harness side connector and the No. 15 (Red/Blue) terminal of the ECM connector A. Is there the continuity? YES – Repair short in the wire between the ECM and the spool solenoid valve. NO – Perform “4. VTEC signal line open circuit check”. 4. VTEC signal line open circuit check -1.
Check for the continuity between the spool solenoid valve harness side connector terminal and the No. 20 (Green/Yellow) terminal of the ECM connector A. KNOCK SENSOR HARNESS SIDE 1P CONNECTOR ECM CONNECTOR A SPOOL SOLENOID VALVE HARNESS SIDE CONNECTOR KS (RED/BLUE) ECM CONNECTOR A VTS (GREEN/YELLOW) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “3. Knock sensor signal line short cir- cuit check”. NO – Repair open in the wire between the knock sensor and the ECM. Is there the continuity? YES – Substitute a known-good ECM and recheck. NO – Repair open in the wire between the ECM and the spool solenoid valve. 5-43