BF135A•BF150A 3. Knock sensor signal line short circuit test -1. Check for the continuity between the No.15 (Red/Blue) terminal of the ECM connector A and the body ground. • A/F Heater Troubleshooting DTC 41-3: A/F heater is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up 5 minutes or more by running the engine at 3,000 min -1 (rpm) under no load. -3. Check the DTC again using the HDS pocket tester. ECM CONNECTOR A KS (RED/BLUE) Does the DTC 41-3 appear? YES – Perform “2. A/F heater relay check”.
NO – Temporary failure (Disappeared) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECM and the spool solenoid valve. NO – Substitute a known-good ECM and recheck. 2. A/F heater relay check -1. Turn the ignition switch OFF and disconnect the A/F sensor 4P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (White) terminal of the A/F sensor harness side 4P connector and the engine ground. A/F SENSOR HARNESS SIDE 4P CONNECTOR AFHT+ (WHITE) VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Perform “3. A/F sensor heater check”. NO – Go to the step 3. -3.
Turn the ignition switch OFF and disconnect the A/F heater relay 4P connector. -4. Measure the voltage between the No. 1 (White/ Green) terminal of the A/F heater relay harness side 4P con- nector and the engine ground. Note that the battery voltage is constantly applied to the White/Green terminal. Take care not to short-cir- cuit the terminal. A/F HEATER RELAY HARNESS SIDE 4P CONNECTOR +B (WHITE/GREEN) VIEWED FROM THE TERMINAL SIDE 5-44