BF135A•BF150A 4. Heater line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector C. -2. Check for the continuity between the No. 3 (Black/White) terminal of the ECM connector C and the engine ground, and between the No. 4 (White) ter- minal of the ECM connector C and the engine ground. -3. Check for the continuity between the No. 3 (Black/ White) terminal of the ECM connector C and the respective terminals of the No. 1 (White/Black) and the No. 2 (Black/Yellow) terminals of the A/F sensor har- ness side 4P connector.
A/F SENSOR HARNESS SIDE 4P CONNECTOR ECM CONNECTOR C ECM CONNECTOR C AFV1 (WHITE/ BLACK) AFHT (BLACK/WHITE) AFHT+ (WHITE) AFC1 (BLACK/ YELLOW) AFHT (BLACK/ WHITE) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Go to the step 4. Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Perform “5. Heater line open circuit check”. -4. Check for continuity between the No. 4 (White) termi- nal of the ECM connector C and the respective termi- nals of the No. 1 (White/Black) and the No.
2 (Black/Yellow) terminals of the A/F sensor harness side 4P connector. 5. Heater line open circuit check -1. Turn the ignition switch OFF and connect the A/F sen- sor 4P connector. -2. Measure the resistance between the No. 3 (Black/ White) terminal and the No. 4 (White) terminal of the ECM connector C. ECM CONNECTOR C A/F SENSOR HARNESS SIDE 4P CONNECTOR AFHT+ (WHITE) ECM CONNECTOR C AFV1 (WHITE/ BLACK) AFC1 (BLACK/ YELLOW) AFHT (BLACK/WHITE) AFHT+ (WHITE) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Replace the A/F sensor and recheck.
If it is still abnormal, substitute a known-good ECM and recheck. Is the resistance 2 – 3 (at room temperature)? YES – Perform “6. Sensor line short circuit check”. NO – Repair open in the wire between the A/F sen- sor and the ECM. 6. Sensor line short circuit check -1. Disconnect the ECM connector B. -2. Disconnect the A/F sensor 4P connector. 5-48