honda — Programmed Fuel Injection

BF135A•BF150A • A/F Sensor Troubleshooting -3. Check for the continuity between the No. 2 (Black/Yellow) terminal of the A/F sensor harness side 4P connector and the No. 14 (Black/Yellow) terminal of the ECM connector A. DTC 48-5: A/F sensor current is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up for 5 minutes or more by running the engine at 3,000 min -1 (rpm) under no load. -3. Check the DTC again using the HDS pocket tester. ECM CONNECTOR A A/F SENSOR HARNESS SIDE 4P CONNECTOR AFC1 (BLACK/ YELLOW) Does the DTC 48-5 appear? YES – Perform “2.

A/F sensor line open circuit check”. NO – Temporary failure (Disappears) VIEWED FROM THE TERMINAL SIDE 2. A/F sensor line open circuit check -1. Turn the ignition switch OFF. Disconnect the A/F sen- sor connector and the ECM connector A. -2. Check for the continuity between the No. 1 (White/Black) terminal of the A/F sensor harness side 4P connector and the No. 4 (White/Black) terminal of the ECM connector A. Is there the continuity? YES – Replace the A/F sensor and recheck. If there is abnormality, substitute a known-good ECM and recheck. NO – Repair open in the wire between the A/F sen- sor and the ECM.

ECM CONNECTOR A A/F SENSOR HARNESS SIDE 4P CONNECTOR AFV1 (WHITE/BLACK) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Go to the step 3. NO – Repair open in the wire between the A/F sen- sor and the ECM. 5-49