honda — Programmed Fuel Injection

BF135A•BF150A DTC 48-6: A/F sensor V current is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up 5 minutes or more by running the engine at 3,000 min -1 (rpm) under no load. -3. Check the DTC again using the HDS pocket tester. DTC 48-7: A/F sensor C current is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up for 5 minutes or more by running the engine at 3,000 min -1 (rpm) under no load. -3.

Check the DTC again using the HDS pocket tester. Does the DTC 48-6 appear? YES – Perform “2. A/F sensor line short circuit check”. NO – Temporary failure (Disappeared) Does the DTC 48-7 appear? YES – Perform “2. A/F sensor line short circuit check”. NO – Temporary failure (Disappeared) 2. A/F sensor line (V line) short circuit check -1. Turn the ignition switch OFF. Disconnect the A/F sen- sor connector and the ECM connector A. -2. Check for the continuity between the No. 1 (White/Black) terminal of the A/F sensor harness side 4P connector and the engine ground. 2. A/F sensor line (C line) short circuit check -1. Turn the ignition switch OFF.

Disconnect the A/F sen- sor connector and the ECM connector A. -2. Check for the continuity between the No. 2 (Black/Yellow) terminal of the A/F sensor harness side 4P connector and the engine ground. A/F SENSOR HARNESS SIDE 4P CONNECTOR A/F SENSOR HARNESS SIDE 4P CONNECTOR AFV1 (WHITE/BLACK) AFC1 (BLACK/YELLOW) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Replace the A/F sensor and recheck. If there is any abnormality, substitute a known-good ECM and recheck. Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM.

NO – Replace the A/F sensor and recheck. If it is abnormal, substitute a known-good ECM and recheck. 5-50