BF135A•BF150A • ECT Sensor 2 Troubleshooting DTC 140-2: ECT sensor 2 voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 2 voltage using the HDS pocket tester. DTC 140-1: ECT sensor 2 voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 2 voltage using the HDS pocket tester. Is the measured voltage 0.08 – 4.99V?
YES – Temporary failure (Disappeared) NO – Perform “2. ECT sensor 2 signal line open cir- cuit check”. Is the measured voltage 0.08 – 4.99V? YES – Temporary failure (Disappeared) NO – Perform “2. ECT sensor 2 signal line short cir- cuit check”. 2. ECT sensor 2 signal line open circuit check -1. Turn the ignition switch OFF and disconnect the 2P connector from the ECT sensor 2. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (Red/Black) terminal of the ECT sensor 2 harness side 2P con- nector and the engine ground. 2. ECT sensor 2 signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the ECT sen- sor 2 connector and the ECM connector B. -2.
Check for the continuity between the No. 2 (Red/Black) terminal of the ECT sensor 2 harness side 2P con- nector and the body ground. ECT SENSOR 2 HARNESS SIDE 2P CONNECTOR ECT SENSOR 2 HARNESS SIDE 2P CONNECTOR TOH1 (RED/BLACK) TOH1 (RED/BLACK) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECT sensor 2 and the ECM. NO – Perform “3. ECT sensor 2 check”. Is the measured voltage 4.75 – 5.25V? YES – Perform “3. ECT sensor 2 ground line open circuit check”. NO – Repair open in the wire between the ECT sensor 2 and the ECM. 3. ECT sensor 2 check -1.
Turn the ignition switch OFF and connect the ECT sen- sor 2 2P connector. -2. Turn the ignition switch ON and measure the ECT sen- sor 2 temperature using the HDS pocket tester. Does the measurement correspond to the engine coolant temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 2. 5-51