honda — Programmed Fuel Injection

BF135A•BF150A 3. ECT sensor 2 ground line open circuit check -1. Connect the ECM connector B. -2. Check for the continuity between the No. 1 (Green/ Red) terminal of the ECT sensor 2 harness side 2P connector and the body ground. • ECT Sensor 3 Troubleshooting DTC 141-1: ECT sensor 3 voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 3 voltage using the HDS pocket tester. ECT SENSOR 2 HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) Is the measured voltage 0.08 – 4.99V? YES – Temporary failure (Disappeared) NO – Perform “2.

ECT sensor 3 signal line short cir- cuit check”. VIEWED FROM THE TERMINAL SIDE 2. ECT sensor 3 signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the ECT sen- sor 3 connector and the ECM connector B. -2. Check for the continuity between the No. 2 terminal (Red) of the ECT sensor 3 harness side 2P connector and the body ground. Is there the continuity? YES – Perform “4. ECT sensor 2 check”. NO – Repair open in the wire between the ECT sensor 2 and the engine ground. 4. ECT sensor 2 check -1. Turn the ignition switch OFF and connect all the con- nectors. -2. Turn the ignition switch ON. Measure the ECT sensor 2 temperature using the HDS pocket tester.

ECT SENSOR 3 HARNESS SIDE 2P CONNECTOR TOH2 (RED) Does the measurement correspond to the engine coolant temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 2. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECT sensor 3 and the ECM. NO – Perform “3. ECT sensor 3 check”. 3. ECT sensor 3 check -1. Turn the ignition switch OFF and connect the ECT sen- sor 3 2P connector. -2. Turn the ignition switch ON and measure the ECT sen- sor 3 temperature using the HDS pocket tester. Does the measurement agree with the engine coolant temperature? YES – Substitute a known-good ECM and recheck.

NO – Replace the ECT sensor 3. 5-52