BF135A•BF150A DTC 141-2: ECT sensor 3 voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 3 voltage using the HDS pocket tester. 3. ECT sensor 3 ground line open circuit check -1. Connect the ECM connector B. -2. Check for continuity between the No. 1 (Green/Red) terminal of the ECT sensor 3 harness side 2P con- nector and the body ground. ECT SENSOR 3 HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) (GREEN/RED) Is the measured voltage 0.08 – 4.99V? YES – Temporary failure (Disappeared) NO – Perform “2.
ECT sensor 3 signal line open cir- cuit check”. 2. ECT sensor 3 signal line open circuit check -1. Turn the ignition switch OFF and disconnect the 2P connector from the ECT sensor 3. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (Red) terminal of the ECT sensor 3 harness side 2P connector and the engine ground. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “4. ECT sensor 3 check”. NO – Repair open in the wire between the ECT sensor 3 and the engine ground. ECT SENSOR 3 HARNESS SIDE 2P CONNECTOR 4. ECT sensor 3 check -1. Turn the ignition switch OFF and connect all the con- nectors. -2.
Turn the ignition switch ON and measure the ECT sen- sor 3 temperature using the HDS pocket tester. TOH2 (RED) Does the measurement agree with the engine coolant temperature? YES – When the DTC appears again, substitute a known-good ECM and recheck. NO – Replace the ECT sensor 3. VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform “3. ECT sensor 3 ground line open circuit check”. NO – Repair open in the wire between the ECT sensor 3 and the ECM. 5-53