honda — Programmed Fuel Injection

BF135A•BF150A EOP switch (High pressure side) Troubleshooting 3. EOP switch signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the EOP switch 2P connector and the ECM connector A. -2. Check for the continuity between the No. 1 (Yellow/Red) terminal of the EOP switch harness side 2P connector and the body ground. DTC 142-1: EOP switch signal is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Check the EOP switch signal using the HDS pocket tester.

EOP SWITCH HARNESS SIDE 2P CONNECTOR OPSH (YELLOW/RED) Is there the OFF signal? YES – Temporary failure (Disappeared) NO – Perform “2.EOP switch signal line open circuit check”. 2. EOP switch signal line open circuit check -1. Turn the ignition switch OFF and disconnect the EOP switch 2P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 1 (Yellow/Red) terminal of the EOP switch harness side 2P connector and the body ground. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the EOP switch and the ECM. NO – Perform “4. EOP switch ground line open cir- cuit check”. EOP SWITCH HARNESS SIDE 2P CONNECTOR 4.

EOP switch ground line open circuit check -1. Check for the continuity between the No. 2 (Green/Red) terminal of the EOP switch harness side 2P connector and the body ground. OPSH (YELLOW/RED) EOP SWITCH HARNESS SIDE 2P CONNECTOR VIEWED FROM THE TERMINAL SIDE SG2 (GREEN/RED) Is there the battery voltage? YES – Perform “3.EOP switch signal line short circuit check”. NO – Repair open in the wire between the EOP switch and the ECM. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “5. EOP switch check”. NO – Repair open in the wire between the EOP switch and the ECM. 5-54