BF135A•BF150A 5. EOP switch check -1. Turn the ignition switch OFF and connect all the con- nectors. -2. Turn the ignition switch ON and check the EOP switch using the HDS pocket tester. • ECT Sensor 4 Troubleshooting DTC 143-1: ECT sensor 4 voltage is low 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 4 voltage using the HDS pocket tester. Does the tester shows the switch OFF? YES – If the DTC appears again, substitute a known- good ECM and recheck. NO – Replace the EOP switch. Is the measured voltage 0.08 – 4.99V?
YES – Temporary failure (Disappeared) NO – Perform “2. ECT sensor 4 signal line short cir- cuit check”. 2. ECT sensor 4 signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the ECT sen- sor 4 connector and the ECM connector B. -2. Check for the continuity between the No. 2 (Red/Green) terminal of the ECT sensor 4 harness side connector and the body ground. ECT SENSOR 4 HARNESS SIDE 2P CONNECTOR TOH3 (RED/GREEN) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECT sensor 4 and the ECM. NO – Perform “3. ECT sensor 4 check”. 3. ECT sensor 4 check -1. Turn the ignition switch OFF and connect the ECT sen- sor 4 2P connector.
-2. Turn the ignition switch ON. Measure the ECT sensor 4 temperature using the HDS pocket tester. Does the measurement correspond to the engine coolant temperature? YES – If the DTC appears again, substitute a known- good ECM and recheck. NO – Replace the ECT sensor 4. 5-55