honda — Programmed Fuel Injection

BF135A•BF150A DTC 143-2: ECT sensor 4 voltage is high 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Turn the ignition switch ON. -3. Measure the ECT sensor 4 voltage using the HDS pocket tester. 3. ECT sensor 4 ground line open circuit check -1. Connect the ECM connector B. -2. Check for the continuity between the No. 1 (Green/Red) terminal of the ECT sensor 4 harness side 2P connector and the body ground. ECT SENSOR 4 HARNESS SIDE 2P CONNECTOR Is the measured voltage 0.08 – 4.99V? YES – Temporary failure (Disappeared) NO – Perform “2. ECT sensor 4 signal line open cir- cuit check”.

SG2 (GREEN/RED) 2. ECT sensor 4 signal line open circuit check -1. Turn the ignition switch OFF and disconnect the 2P connector from the ECT sensor 4. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (Red/Green) terminal of the ECT sensor 4 harness side 2P con- nector and the engine ground. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “4. ECT sensor 4 check”. NO – Repair open in the wire between the ECT sensor 4 and the engine ground. 4. ECT sensor 4 check -1. Turn the ignition switch OFF and connect all the con- nectors. -2. Turn the ignition switch ON and measure the ECT sen- sor 4 temperature using the HDS pocket tester.

ECT SENSOR 4 HARNESS SIDE 2P CONNECTOR TOH3 (RED/GREEN) Does the measurement correspond to the engine coolant temperature? YES – When the DTC appears again, substitute a known-good ECM and recheck. NO – Replace the ECT sensor 4. VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform “3. ECT sensor 4 ground line open circuit check”. NO – Repair open in the wire between the ECT sensor 4 and the ECM. 5-56