honda — Programmed Fuel Injection

BF135A•BF150A • ECM Reset Procedure 7. TROUBLESHOOTING WITHOUT HDS TESTER 1. Turn the ignition switch OFF. • Check of Number of Blinks of MIL 2. Short-circuit the 4P (Red) data link connector located inside the electric part cover using the special tool (SCS short connector). 1. Remove the engine cover and the electric part cover (Section 4). 2. Disconnect the red 4P connector and connect (short- circuit) the SCS short connector to the DLC (Data Link Connector). 3. Turn the ignition switch ON. 4P CONNECTOR (RED) 4. Turn the emergency stop switch ON (push) and OFF (release). Repeat this procedure five times. (Repeat turning the switch ON for 0.5 sec. or more and turning it OFF for 0.1 sec.

or more.) 5. Check that the buzzer sounds twice. The MIL should stay ON. 6. Turn the ignition switch OFF. (ECM reset procedure completes.) Perform the step 4 through the step 6 within 20 sec- onds. ON (Push) 0.5 sec. or more SCS SHORT CONNECTOR 070PZ-ZY30100 DLC (DATA LINK CONNECTOR) OFF (Release) 3. Check the number of blinks of the MIL. 0.1 sec. or more Count the number of blinks when the MIL starts blink- ing. The diagnostic trouble code (DTC) is indicated repeatedly. The number of long blinks equals the first digit and the number of short blinks equals the sec- ond digit of the DTC. Within 20 sec.

BUZZER ON OFF IGNITION SWITCH ON IGNITION SWITCH OFF When multiple problems occur simultaneously, the MIL repeatedly indicates them by blinking separate codes, one after another. Separate problems: See DTC 1. See DTC 3. See DTC 14. Multiple problems: See DTC 1 and 3. See DTC 3 and 4. See DTC 1 and 14 5-57