honda — Programmed Fuel Injection

BF135A•BF150A Final Procedure (After Troubleshooting) • Connecting Test Harness 1. Disconnect the SCS short connector from the data link connector. Note that the MIL stays ON while the SCS short con- nector is connected to the data link connector. Use the test harness (special tool) and a commercially available digital circuit tester for troubleshooting. Disconnect the test harness sensor connector if the instruction tells to do so for troubleshooting. 2. Be sure to reset the ECM after troubleshooting. The MIL can come ON or blink when the ECM detect- ed poor or loose contact of a connector.

If it is hard to identify the problem part by following the troubleshoot- ing flow chart, check the three connectors of the ECM and the connector of the probable faulty part, and clean or repair the connector(s) if necessary. TEST HARNESS 070PZ-ZY60100 TEST HARNESS SEN- SOR CONNECTOR ECM If the problem cannot be identified by the above pro- cedure, check by following the troubleshooting for the fuel supply system (P. 5-96). C CONNECTOR (6P) CONNECTOR C CONNECTOR A A CONNECTOR (26P) DIGITAL CIRCUIT TESTER (Commercially available) CONNECTOR B B CONNECTOR (34P) 5-58