honda — Programmed Fuel Injection

BF135A•BF150A 3. IGP power supply line check -1. Turn the ignition switch OFF and disconnect the PGM- FI main relay 6P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 2 (Black/Yellow) terminal of the PGM- FI main relay harness side 6P connector and the engine ground. 4. ECM power supply line check -1. Turn the ignition switch OFF and disconnect the fuse box 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (Yellow/Black) terminal of the fuse box side 3P connector and the engine ground.

FUSE BOX SIDE 3P CONNECTOR PGM-FI MAIN RELAY HARNESS SIDE 6P CONNECTOR BLACK/YELLOW YELLOW/BLACK VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Go to the step 3. NO – PGM-FI main relay is faulty, or fuse box is faulty. Is there the battery voltage? YES – Go to the step 3. NO – Repair open in the main harness wire. -3. Turn the ignition switch OFF. Check for the continuity between the No. 6 (Black) terminal of the PGM-FI main relay 6P connector and the engine ground. -3. Turn the ignition switch OFF and disconnect the ECM connector C. -4.

Check for the continuity between the No.2 (Yellow/Black) terminal of the fuse box harness side 3P connector and the respective terminals of the No. 1 (Yellow/Black) and the No. 5 (Yellow/Black) terminals of the ECM connector C. PGM-FI MAIN RELAY HARNESS SIDE 6P CONNECTOR BLACK ECM CONNECTOR C FUSE BOX HARNESS SIDE 3P CONNECTOR VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “4. ECM power supply line check”. NO – Repair open in the main harness (Black) wire. YELLOW/BLACK VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “5. MIL power supply line check”. NO – Repair open in the main harness wire. 5-62