BF135A•BF150A 5. MIL power supply line check -1. Turn the ignition switch OFF and disconnect the fuse box 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 2 (Yellow/Red) terminal of the fuse box side 3P connector and the engine ground. 6. Alternator indicator light check -1. Turn the ignition switch ON and check the alternator indicator light. Does the alternator indicator light come ON? YES – Perform “7. MIL ON line check”. NO – Replace the MIL. FUSE BOX SIDE 3P CONNECTOR 7. MIL ON line check -1. Turn the ignition switch OFF and connect the test har- ness. -2. Connect the test harness B-25 terminal to the engine ground to short-circuit.
Turn the ignition switch ON and check the MIL. YELLOW/RED VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Go to the step 3. NO – PGM-FI main relay is faulty. B-25 -3. Turn the ignition switch OFF and connect the fuse box 3P connector. -4. Disconnect the MIL 6P connector. -5. Turn the ignition switch ON. Measure the voltage between the No. 6 (Yellow/Red) terminal of the MIL harness side 6P connector and the engine ground. Does the MIL come ON? YES – Substitute a known-good ECM and recheck. NO – Repair open in the main harness wire between the MIL and the ECM. MIL HARNESS SIDE 6P CONNECTOR YELLOW/RED VIEWED FROM THE TERMINAL SIDE Is there the battery voltage?
YES – Perform “6. Alternator indicator light check”. NO – Repair open in the main wire harness. 5-63