honda — Programmed Fuel Injection

BF135A•BF150A • MIL ON but MIL Does Not Blink With SCS Circuit Shorted -6. Connect the SCS short connector to the data link con- nector to short-circuit. -7. Measure the voltage between the test harness B-16 terminal (+) and A-1 (–) terminal, and between the B- 16 terminal (+) and B-17 terminal (–). 1. Engine start check -1. Disconnect the SCS short connector and start the engine. A-1 B-16 Does the engine start? YES – Perform “2. Data link connector line check”. NO – Perform “3. Sensor check”. B-17 2. Data link connector line check -1. Turn the ignition switch OFF and connect the test har- ness (P. 5-58). -2. Disconnect the test harness sensor connector. -3. Turn the ignition switch ON.

Measure the voltage between the test harness B-16 terminal (+) and A-1 terminal (–), and between the B-16 terminal (+) and B- 17 terminal (–). Is the measured voltage 4.30 – 5.25V? YES – Go to the step 8. NO – Go to the step 10. -8. Disconnect the SCS short connector. -9. Turn the ignition switch OFF. Check for the continuity between the data link connector No. 1 (Black) terminal and the engine ground. A-1 B-16 DATA LINK CONNECTOR B-17 Is the measured voltage 4.30 – 5.25V? YES – Go to the step 4. NO – Substitute a known-good ECM and recheck. VIEWED FROM THE TERMINAL SIDE -4. Turn the ignition switch OFF and connect the test har- ness. -5. Turn the ignition switch ON.

Measure the voltage between the test harness B-16 terminal (+) and A-1 terminal (–), and between the B-16 terminal (+) and B- 17 terminal (–). Is there the continuity? YES – Repair open in the main harness between the data link connector and the ECM. NO – Repair open in the main harness between the data link connector and the engine ground. A-1 B-16 -10.Disconnect the SCS short connector from the data link connector. -11.Turn the ignition switch OFF and disconnect the ECM connector A. -12.Turn the ignition switch ON and check that the MIL comes ON. B-17 Is the measured voltage 4.30 – 5.25V? YES – Repair open in the wire harness between the ECM and the data link connector.

NO – Go to the step 6. Does the MIL come ON? YES – Repair short in the main harness (Red/Blue) between the MIL and the ECM. NO – Substitute a known-good ECM and recheck. 5-64