honda — Programmed Fuel Injection

BF135A•BF150A 3. Sensor check -1. Turn the ignition switch ON. -2. Disconnect the MAP sensor 3P connector and check the MIL. -9. With the ECU connector A disconnected, check for the continuity between the test harness A-12 terminal and the engine ground. Does the MIL go OFF? YES – Replace the MAP sensor. NO – Go to the step 3. A-12 -3. Connect the MAP sensor 3P connector. -4. Disconnect the TP sensor 3P connector and check the MIL. Is there the continuity? YES – Repair open in the wire between the ECM and the BARO sensor. NO – Perform “4. ECM main power supply line check”. Does the MIL go OFF? YES – Replace the TP sensor. NO – Go to the step 5. -5. Connect the TP sensor 3P connector. -6.

Disconnect the BARO sensor 3P connector and check the MIL. 4. ECM main power supply line check -1. Connect the ECM connector A. -2. Check for the continuity between the test harness C-1 terminal and the respective terminals of A-1 and B-17 terminals. Measure the voltage between the test harness C-5 ter- minal and the respective terminals of A-1 and B-17 ter- minals. Does the MIL go OFF? YES – Replace the BARO sensor. NO – Go to the step 7. -7. Turn the ignition switch OFF and connect the test har- ness. -8. Check for the continuity between the test harness B-4 terminal and the engine ground with the ECM connec- tor A disconnected. A-1 C-1 B-4 C-5 B-17 Is there the continuity?

YES – Substitute a known-good ECM and recheck. NO – Check the PGM-FI main relay harness (P. 5- 97). Is there the continuity? YES – Repair open in the main harness between the ECM and the MAP sensor. NO – Go to the step 9. 5-65