BF135A•BF150A Alert System Initial Operation Is Faulty -3. Turn the ignition switch OFF and disconnect the Yellow/Green terminal from the buzzer. -4. Connect the Yellow/Green terminal of the buzzer to the Black terminal with a jumper wire to short-circuit. -5. Turn the ignition switch ON and check whether the buzzer sounds. 1. Wire harness short-circuit check -1. Turn the ignition switch OFF and connect the test har- ness. -2. Disconnect the ECM connector A, B and C from the ECM. -3. Turn the ignition switch ON and check whether the buzzer sounds. Does the buzzer sound? YES – Repair open in the wire between the buzzer and the ECM. NO – Go to the step 6. Does the buzzer sound?
YES – Repair short in the wire between the buzzer and the ECM. NO – Go to the step 4. -6. Check the buzzer (single unit check). Is the buzzer normal? YES – Go to the step 7. NO – The buzzer is faulty. -4. Check the oil pressure indicator light. Does the oil pressure indicator light come ON? YES – Go to the step 5. NO – Repair short in the wire between the oil pres- sure indicator light and the ECM. -7. Check the ignition switch (single unit check) (P. 16-9). Is the ignition switch normal? YES – Go to the step 8. NO – The ignition switch is faulty. -5. Check the overheat indicator light. Does the overheat indicator light come ON?
YES – Repair short in the wire between the overheat indicator light and the ECM. NO – Go to the step 6. -8. Disconnect the remote control box harness side 14P connector. -9. Turn the ignition switch ON. Check for the continuity between the No. 1 (White/Black) and the No. 2 (Black/Yellow) terminals of the remote control box har- ness side 14P connector. -6. Check the MIL. Does the MIL come ON? YES – Repair short in the wire between the MIL and the ECM. NO – Perform "2. Buzzer line check". REMOTE CONTROL HARNESS SIDE 14P CONNECTOR WHITE/BLACK BLACK/YELLOW 2. Buzzer line check -1. Connect the test harness B-18 terminal to the engine ground to short-circuit. -2.
Turn the ignition switch ON and check that the buzzer sounds. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair open in the main harness. NO – Repair open in the remote control box har- ness. B-18 Does the buzzer sound? YES – Perform “3. Overheat indicator line check”. NO – Go to the step 3. 5-66