honda — Programmed Fuel Injection

BF135A•BF150A 3. Overheat indicator line check -1. Connect the test harness B-31 terminal to the engine ground to short-circuit. -2. Turn the ignition switch ON and check that the over- heat indicator light comes ON. 4. Oil pressure indicator line check -1. Connect the test harness B-32 terminal to the engine ground to short-circuit. -2. Turn the ignition switch ON and check the oil pressure indicator light. B-31 B-32 Does the overheat indicator light come ON? YES – Perform "4. Oil pressure indicator line check". NO – Go to the step 3. Does the oil pressure indicator light come ON? YES – Go to the step 3. NO – Perform "5. MIL line check". -3. Turn the ignition switch OFF.

Disconnect the indicator light Red terminal and connect it to the Black terminal with a jumper wire to short-circuit. -4. Turn the ignition switch ON and check the overheat indicator light. -3. Turn the ignition switch OFF. Disconnect the indicator light Yellow terminal and connect it to the Black termi- nal with a jumper wire to short-circuit. -4. Turn the ignition switch ON and check the oil pressure indicator light. Does the overheat indicator light come ON? YES – Repair open in the wire between the ECM and the indicator light. NO – Go to the step 5. Does the oil pressure indicator light come ON? YES – Go to the step 5. NO – Repair open in the wire between the ECM and the indicator light.

-5. Turn the ignition switch OFF and connect the indicator light Red terminal. -6. Disconnect the remote control harness 14P connector. -7. Check for the continuity between the No. 7 (Red) and the No. 2 (Black/Yellow) terminals of the remote control harness side 14P connector. -5. Turn the ignition switch OFF and connect the indicator light Yellow terminal. -6. Disconnect the remote control harness 14P connector. -7. Check for the continuity between the No.6 (Yellow) and the No. 2 (Black/Yellow) terminals of the remote control harness side 14P connector.

REMOTE CONTROL HARNESS SIDE 14P CONNECTOR REMOTE CONTROL HARNESS SIDE 14P CONNECTOR BLACK/YELLOW BLACK/YELLOW YELLOW RED VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair open in the main harness. NO – The indicator light is faulty, or repair open in the remote control harness. Is there the continuity? YES – Repair open in the main harness. NO – The indicator light is faulty, or repair open in the remote control harness. 5-67