honda — Programmed Fuel Injection

BF135A•BF150A • MAP Sensor Troubleshooting 3. MAP sensor signal line open circuit check -1. Connect the ECM connector A. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (White/Red) terminal of the MAP sensor harness side 3P connec- tor and the engine ground. MIL blinks 3 times. 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the test harness B-5 ter- minal (+) and the B-6 terminal (–).

MAP SENSOR HARNESS SIDE 3P CONNECTOR PB (WHITE/RED) B-6 B-5 VIEWED FROM THE TERMINAL SIDE Is the measured voltage 0.22 – 3.15V? YES – Temporary failure (Disappeared) NO – Perform "2. MAP sensor signal line short cir- cuit check". Is the measurement 4.75 – 5.25V? YES – Perform "4. MAP sensor signal line short cir- cuit check". NO – Repair open in the wire between the ECM and the MAP sensor. 2. MAP sensor signal line short circuit check -1. Turn the ignition switch OFF and disconnect the MAP sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (Brown/Yellow) terminal of the MAP sensor harness side 3P connector and the engine ground. 4.

MAP sensor signal line short circuit check -1. Check for the continuity between the No. 2 (White/ Red) terminal of the MAP sensor harness side 3P con- nector and the body ground. MAP SENSOR HARNESS SIDE 3P CONNECTOR MAP SENSOR HARNESS SIDE 3P CONNECTOR VCC1 (BROWN/YELLOW) PB (WHITE/RED) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the MAP sensor and the ECM. NO – Perform “5. MAP sensor ground line open cir- cuit check”. Is the measured voltage 4.75 – 5.25V? YES – Perform "3. MAP sensor signal line open cir- cuit check". NO – Repair open in the wire between the ECM and the MAP sensor. 5-71