honda — Programmed Fuel Injection

BF135A•BF150A 5. MAP sensor ground line open circuit check -1. Check for the continuity between the No. 1 (Green/ Red) terminal of the MAP sensor harness side 3P con- nector and the body ground. • CKP Sensor Troubleshooting MIL blinks 4 times. 1. Symptom reproduction test -1. Reset the ECM. -2. Start the engine and let it run at idling under no load. -3. Check the MIL. MAP SENSOR HARNESS SIDE 3P CONNECTOR SG1 (GREEN/RED) Does the MIL come ON? YES – Perform "2. CKP sensor power supply line open circuit check". NO – Temporary failure (Disappeared) VIEWED FROM THE TERMINAL SIDE 2. CKP sensor power supply line open circuit check -1.

Turn the ignition switch OFF and disconnect the CKP sensor 3P connector. -2. Turn the ignition switch ON and measure the voltage between the No. 1 (Yellow/Black) terminal of the CKP sensor harness side 3P connector and the engine ground. Is there the continuity? YES – Perform “6. MAP sensor check”. NO – Repair open in the wire between the MAP sensor and the ECM. 6. MAP sensor check -1. Connect the MAP sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the test harness B-5 terminal (+) and the B-6 terminal (–). CKP SENSOR HARNESS SIDE 3P CONNECTOR IGP (YELLOW/BLACK) B-6 B-5 VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Perform "3.

CKP sensor signal line open cir- cuit check". NO – Repair open in the wire between the ECM and CKP sensor. Is the measurement 2.76 – 2.96V? YES – Substitute a known-good ECM and recheck. NO – Replace the MAP sensor. 3. CKP sensor signal line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 3 (Blue) terminal of the CKP sensor harness side 3P connector and the engine ground. CKP SENSOR HARNESS SIDE 3P CONNECTOR CRK (BLUE) VIEWED FROM THE TERMINAL SIDE 5-72