BF135A•BF150A 6. CKP sensor check -1. Reset the ECM. -2. Start the engine and let it run at idling under no load. Check the MIL. Is the measured voltage 4.75 – 5.25V? YES – Perform "4. CKP sensor signal line short cir- cuit check". NO – Repair open in the wire between the CKP sensor and the ECM. Does the MIL come ON? YES – Replace the CKP sensor and recheck. If the MIL comes ON again, substitute a known- good ECM and recheck. NO – End of the check. 4. CKP sensor signal line short circuit check -1. Turn the ignition switch OFF. Check for the continuity between the No. 3 (Blue) terminal of the CKP sensor harness side 3P connector and the engine ground.
CKP SENSOR HARNESS SIDE 3P CONNECTOR CRK (BLUE) Is there the continuity? YES – Perform "5. CKP sensor ground line open cir- cuit check". NO – Repair open in the wire between the CKP sensor and the ECM. VIEWED FROM THE TERMINAL SIDE 5. CKP sensor ground line open circuit check -1. Check for the continuity between the No. 2 (Green/ Black) terminal of the CKP sensor harness side 3P connector and the engine ground. CKP SENSOR HARNESS SIDE 3P CONNECTOR LG1 (GREEN/BLACK) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform "6. CKP sensor check". NO – Repair open in the wire between the CKP sensor and the ECM. 5-73