honda — Programmed Fuel Injection

BF135A•BF150A 3) Disconnect the pressure regulator control tube from the pressure regulator, and clamp the vacuum tube. PRESSURE REGULATOR CONTROL TUBE TUBE CLAMP (Commercially available) 4) Remove the propeller. Set the outboard motor gear case in a test tank filled with water. Start the engine and measure the fuel pressure at idling. 5) When the fuel pressure is outside the specified standard pressure, check the following. When fuel pressure is higher than standard pres- sure: Check the pressure regulator return hose for kinking, col- lapse or restrictions. Check the pressure regulator for proper operation (Inspection: P. 5-106). When the fuel pressure is lower than the standard pressure:

PRESSURE REGULATOR SERVICE CHECK BOLT 12 N·m (1.2 kgf·m, 9 lbf·ft) Check the pressure regulator for proper operation (Inspection: P. 5-106). Check the high pressure side fuel strainer for clogging (Replacement: P.3-18). Check the high pressure side fuel pump for proper oper- ation (Inspection: P. 5-107). 6) After check, replace the sealing washer with a new one and tighten the service check bolt to the specified torque. TORQUE: 12 N m (1.2 kgf m, 9 lbf ft) SEALING WASHER Do not reuse. 7) Connect the vacuum tube to the pressure regulator. 5-103 Standard fuel pressure (At idle speed of 650 ± 50 min-1 /rpm) 270 – 320 kPa (2.8 – 3.3 kgf/cm2, 39.8 – 46.9 psi)