honda — Programmed Fuel Injection

BF135A•BF150A • How To Relive Fuel Pressure SHOP TOWEL Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. Disconnect the battery cable from the battery negative (-) ter- minal before relieving the fuel pressure. Replace the sealing washer when the service check bolt is loosened or removed. SERVICE CHECK BOLT SERVICE CHECK BOLT 1) Remove the engine cover (P. 4-2). 2) Set an offset wrench on the 6 mm service check bolt of the vapor separator. Place a shop towel or equivalent material over the service check bolt.

3) Loosen the service check bolt approximately one turn slow- ly to relieve the fuel pressure. 4) After relieving the fuel pressure, remove the service check bolt and replace the 6 mm sealing washer with a new one. 5) Tighten the service check bolt to the specified torque. TORQUE: 12 N m (1.2 kgf m, 9 lbf ft) SEALING WASHER Do not reuse. • Fuel Pressure Measurement 1) Relieve the fuel pressure according to “How to relive fuel pressure” explained above. 2) Remove the service check bolt and set the special tool (fuel pressure gauge set) in the threaded bolt hole. FUEL PRESSURE GAUGE SET 07406-0040002 5-102