honda — Programmed Fuel Injection

BF135A•BF150A Check without test harness: 1. Turn the ignition switch OFF and disconnect the 2P connector from the respective injectors. Is there the continuity? YES – Repair open in the wire between the ECM and the injector. NO – Go to the step 5. 2. Disconnect the ECM connector B and C. 5. Connect the injector 2P connector. 3. Check for the continuity between the ECM connector B and each injector harness side 2P connector: ECM connector B Injector No.21 (Brown) 6. Turn the ignition switch ON. Measure the voltage between the No.1 (Yellow/Black) terminal of each injector harness side terminal and the engine ground.

No.2 (Brown) of the No.1 injector No.23 (Red) No.2 (Red) of the No.2 injector No.27 (Blue) INJECTOR HARNESS SIDE 2P CONNECTOR No.2 (Blue) of the No.3 injector No.29 (Yellow) No.2 (Yellow) of the No.4 injector YELLOW/BLACK ECM CONNECTOR B VIEWED FROM THE TERMINAL SIDE BROWN RED BLUE YELLOW Is there the battery voltage? YES – End of the check (Good) NO – Check the injector (P. 5-105). If it is normal, repair open in the wire between the No.4 (15A) fuse and the injector. No. 1 No. 2 No. 3 No. 4 INJECTOR HARNESS SIDE 2P CONNECTORS VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Go to the step 4. NO – Repair open in the wire between the injector and the ECM. 4.

Check for the continuity between the injector harness side 2P connector terminal and engine ground: No.2 (Brown) of No.1 injector and engine ground. No.2 (Red) of No.2 injector and engine ground. No.2 (Blue) of the No.3 injector and engine ground. No.2 (Yellow) of the No.4 injector and engine ground INJECTOR HARNESS SIDE 2P CONNECTORS No. 1 No. 2 No. 3 No. 4 BROWN RED BLUE YELLOW VIEWED FROM THE TERMINAL SIDE 5-101