honda — Programmed Fuel Injection

BF135A•BF150A • Injector Harness Inspection Check with test harness: 1. Turn the ignition switch OFF and disconnect each 2P connector from the respective injectors. Is there the continuity? YES – Repair open in the wire between the ECM and the injector NO – Go to the step 5. 2. Connect the test harness. Disconnect the connector A, B, and C from the ECM. 5. Connect each injector 2P connector. 6. Turn the ignition switch ON. Check for the voltage between the test harness and engine ground: B-21 terminal and the engine ground B-23 terminal and the engine ground B-27 terminal and the engine ground B-29 terminal and the engine ground 3.

Check for the continuity between the test harness and each injector harness side 2P connector: B-21 No.2 (Brown) of the No.1 injector B-23 No.2 (Red) of the No.2 injector B-27 No.2 (Blue) of the No.3 injector B-29 No.2 (Yellow) of the No.4 injector B-23 B-27 B-21 B-29 B-23 B-27 B-21 B-29 Is there the battery voltage? YES – End of the check (Good) NO – Check the injector (P. 5-105). If it is normal, repair open in the wire between the No.4 (15A) fuse and the injector. INJECTOR HARNESS SIDE 2P CONNECTORS BROWN RED BLUE YELLOW No. 1 No. 2 No. 3 No. 4 VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Go to the step 4. NO – Repair open in the wire between the injector and ECM. 4.

Check for the continuity between the test harness and engine ground: B-21 terminal and the engine ground, B-23 terminal and the engine ground B-27 terminal and the engine ground B-29 terminal and the engine ground. B-23 B-27 B-21 B-29 5-100