BF135A•BF150A • Pressure Regulator Inspection Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. If the fuel pressure is lower than the specified standard pres- sure, check the high pressure side fuel pump (P. 5-107), then check the pressure regulator. 1) Check that the pressure regulator control tube is not bent, disconnected and damaged. 2) Remove the service check bolt. Set the special tool (fuel pressure gauge set) in the threaded bolt hole. FUEL PRESSURE GAUGE SET 07406-0040002 3) Remove the propeller.
Set the gear case in a test tank filled with water and start the engine. TUBE CLAMP (Commercially available) PRESSURE REGULATOR CONTROL TUBE 4) With the engine idling, disconnect the pressure regulator control tube from the pressure regulator and clamp it. 5) Check the fuel pressure. It should be higher than the pres- sure measured with the vacuum tube connected. 6) When the fuel pressure does not rise, connect the vacuum tube to the pressure regulator. Pinch the pressure regula- tor return hose that goes from the pressure regulator to the vapor separator a couple of times lightly, and measure the fuel pressure again.
PRESSURE REGULATOR NOTICE SHOP TOWEL PRESSURE REGULATOR RETURN HOSE Protect the pressure regulator return hose by winding a shop towel or equivalent material around the hose, and lightly pinch the hose with the pliers. 7) If the measurement is outside the specified standard pres- sure, replace the pressure regulator (P. 5-136). PLIERS 5-106 Standard fuel pressure (At idle speed of 650 ± 50 min-1 /rpm) 270 – 320 kPa (2.8 – 3.3 kgf/cm2, 40 – 47 psi)