honda — Programmed Fuel Injection

BF135A•BF150A Fuel Pump (High pressure side) Inspection FUEL PUMP 2P CONNECTOR Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. Turn the ignition switch OFF before disconnecting and con- necting the connectors. Use a known-good battery. CONNECTOR BRACKET 1) Remove the engine cover (P. 4-2). 2) Turn the ignition switch ON. Check that the fuel pump oper- ation sound can be heard for approximately 2 seconds. BLACK Is there the fuel pump operation sound? YES – Check the gasoline discharge volume. NO – Go to the step 3.

ENGINE GROUND 3) Remove the high pressure side fuel pump 2P connector from the connector bracket, and disconnect the connector. 4) Measure the voltage between the Black terminal of the har- ness side connector and the body ground. Is there the continuity? YES – Check the gasoline discharge volume. NO – Go to the step 5. FUEL PUMP HARNESS SIDE 2P CONNECTOR 5) Attach the positive (+) tester lead to the Blue/Yellow (+) ter- minal and the negative (–) tester lead to the Black (–) ter- minal of the harness side connector. Turn the ignition switch ON and be sure that there is battery voltage for approximately 2 seconds. BLACK (–) BLUE/ YELLOW (+) Is there the battery voltage?

YES – Check the gasoline discharge volume (P. 5-108). NO – Check the PGM-FI main relay harness (P. 5-97). FUEL PUMP HARNESS SIDE 2P CONNECTOR 5-107