honda — Programmed Fuel Injection

BF135A•BF150A 11. VAPOR SEPARATOR/FUEL PUMP (HIGH PRESSURE SIDE) a. REMOVAL Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. [2] HARNESS BAND CLIP [3] FUEL PUMP 2P CONNECTOR Relieve the fuel pressure before removing the vapor separa- tor. Disconnect the battery cable from the battery negative (–) terminal before relieving the fuel pressure. Replace the sealing washer with a new one whenever the service check bolt was loosened or removed. [1] CLAMPS [4] CONNECTOR BRACKET 1) Remove the engine cover and the L. engine under cover.

[6] FUEL TUBE 2) Relieve the fuel pressure (P. 5-102). [5] COVER LOCK CABLE 3) Remove the high pressure side fuel pump 2P connector from the connector bracket and disconnect the connector. [1] JOINT PIPE 4) Remove the harness band clip from the connector bracket. 5) Unclamp the cover lock cable and the fuel tube. 6) Remove the 6 x 25 mm flange bolt and disconnect the high pressure side fuel hose. Remove the joint pipe and the O- ring. Replace the O-ring with a new one. 7) Disconnect the air vent tube and the pressure regulator return hose from the vapor separator. [3] FUEL HOSE (HIGH PRESSURE SIDE) [2] O-RING (2) Do not reuse.

6 x 25 [1] PRESSURE REGULATOR RETURN HOSE [2] AIR VENT TUBE [3] VAPOR SEPARATOR 5-111