honda — Programmed Fuel Injection

BF135A•BF150A b. DISASSEMBLY 1) Disconnect the 4.5 x 55 mm fuel tube. 2) Remove the 8 x 35 mm flange bolt and the 8 mm washer. Remove the vapor separator stay. 3) Remove the collar and the vapor separator grommet. [1] COLLAR [7] VAPOR SEPARATOR STAY [2] 8 mm WASHER [6] 3.5 x 420 mm DRAIN TUBE 8 x 35 [5] TUBE CLIP B8 (2) [4] 4.5 x 55 mm FUEL TUBE [3] VAPOR SEPARATOR GROMMET 4) Remove the 6 x 25 mm flange bolt and remove the high pressure side fuel hose. 5) Remove the collar and the O-rings. Replace the O-rings on assembly. 6) Remove the three 5 mm screws and remove the strainer cover, O-ring, fuel strainer and the spring.

[1] FUEL HOSE (HIGH PRESSURE SIDE ) [3] FUEL STRAINER (HIGH PRESSURE SIDE) 6 x 25 [2] STRAINER COVER [9] COLLAR [5] O-RING (2) Do not reuse. [8] 5 mm SCREW (3) [4] FILTER SPRING [7] SERVICE CHECK BOLT [5] O-RING [6] SEALING WASHER Do not reuse. Do not reuse. 5-113