honda — Programmed Fuel Injection

BF135A•BF150A c. INSPECTION FLOAT HEIGHT Check the float height by installing the float properly. 1) Place the vapor separator cover as shown. Measure the distance between the float and vapor separator cover (i.e. float height). Set the special tool at right angles to the float chamber mating surface and measure at the highest position of the float. Float height 31 ± 2.5 mm (1.22 ± 0.10 in) [1] FLOAT LEVEL GAUGE 07401-0010000 2) If the float height is out of the specification, check the float valve and valve seat for wear and damage. 3) If the float valve and valve seat are normal, adjust the float height by gently bending the brass float tab taking care not to damage the float.

• FLOAT Check the float for damage and deformation, and check for the gasoline in the float. Check the float for smooth movement. [2] FLOAT TAB • FLOAT VALVE/VALVE SEAT Check the float valve head and the float valve seat for scores, scratches, wear and damage. [1] VALVE SEAT [3] Replace. [2] Good [4] FLOAT VALVE 5-117