BF135A•BF150A 1) Install the float valve and float pin to the float. [1] SCREW (2) [2] FLOAT PIN 2) Set the float assembly on the vapor separator cover and tighten the two screws to the specified torque. TORQUE: 2.1 N m (0.21 kgf m, 1.5 lbf ft) [3] FLOAT [4] FLOAT VALVE [5] VAPOR SEPARATOR COVER 3) Install the vapor separator grommets on the vapor separator stay. [1] COLLAR (2) 6 x 16 (2) [2] VAPOR SEPARATOR GROMMET (2) 4) Install the vapor separator stay on the vapor separator chamber and tighten the two 6 x 16 mm flange bolts to the specified torque. TORQUE: 12 N m (1.2 kgf m, 9 lbf ft) 5) Install the collars on the vapor separator grommet.
[3] VAPOR SEPARATOR STAY 6) Apply a thin coat of the engine oil to the new cover gasket and install the gasket in the groove in the vapor separator chamber securely. [1] 5 mm SCREW- WASHER (6) [2] VAPOR SEPARATOR COVER 7) Install the vapor separator cover and tighten the 5 mm screw-washers to the specified torque. TORQUE: 3.4 N m (0.35 kgf m, 2.5 lbf ft) [3] COVER GASKET Do not reuse. [4] VAPOR SEPARATOR CHAMBER 5-119